Re: [MiNT] Magnum STe/Mintlib

[Alan Hourihane <alanh@fairlite.co.uk>]

On Thu, 2010-01-14 at 13:34 -0500, Mark Duckworth wrote:
> On 1/14/10 1:17 PM, Alan Hourihane wrote:
> > On Thu, 2010-01-14 at 11:28 -0500, Mark Duckworth wrote:
> >    
> >> Hello all,
> >>
> >> I ordered the Magnum STe PCB prototype to be produced last night :)
> >>
> >> Also, I discovered a problem with mintlib.  If you install mintlib cvs
> >> (get a build from Alan's site), then rebuild the cvs rpm (rpm --rebuild
> >> cvs-xxxx.src.rpm), then install the newly built rpm.  If you check out
> >> the freemint cvs, all is well, but if you move into the freemint cvs
> >> directory and do cvs up to update, it gives the error
> >>
> >> root@arawork:/root/temp/freemint>cvs up
> >> cvs update: cannot open current directory: Is a directory
> >>
> >> I have tried new versus old kernel, gcc 2.95.3 vs 4.4.2, and other
> >> things.  I have isolated this to be something in the mintlib causing it.
> >>      
> > What kernel are you running ?
> >
> > Alan.
> >
> >    
> I tried with both an early 2009 kernel and trunk off your site built at 
> midnight today.  I'm still experimenting to ensure that mintlib is the 
> problem.

Are you running of an ext2 drive ?

If so, did you update the ext2 XFS from the tarball too ?

Alan.